Veneer Panel Anchor Installation
1. Drill a 7/16” hole through the outer panel and approx. 11/2” into the inner wythe. The head may be fitted to the outside face of the panel or recessed below the surface. If the head is to be recessed, drill a 3/4” diameter counter bore into the panel at least 3/16” deep.
2. Screw the threaded end of Setting Tool 1 onto the outer end of the anchor and insert fully into the hole in the far wythe.
3. Turn the Setting Tool 1 until the inner shell has expanded and is tight. Apply the torque wrench to the end of the Setting Tool 1 (1/4“ square) to check the torque – usually 36lbf-ins for standard brick but may be increased to 54lbf-ins for harder substrates.
4. Fit the nut to the anchor shank and tighten with the 1/4” Allen key to provide support and seal against water.
