|
|
PRODUCTS
|
| Crack Stitching & Bonding | Installation Procedures |
|
|
|
| 1 Rake out or cut slots into the horizontal mortar beds, a minimum of 500mm either side of the crack, to the specified depth. | 2
Clean out slots with blow pump and apply HeliBond Primer or flush with water. |
 |
 |
| 3 Using the CS Pointing Gun Kit, inject a bead of HeliBond to the back of the slot. | 4
Using a finger trowel, or similar, push the HeliBar into the grout to obtain good coverage. |
 |
 |
| 5 Inject a further bead of HeliBond over the exposed HeliBar, finishing 10-15mm from the face, and ‘iron’ into the slot using a finger trowel. | 6
Repoint the mortar bed and make good. |
 |
 |
| 7 Make good the vertical crack with a weatherproof filler. e.g. CrackBond TE. | |
